Industrial Automation — datasheet
Sensor and machine signals streamed into Business Central, automatic output counts, run-time capture, and alerts when the line drifts off plan.
In this article
Machine data, posted while it happens.
The machines on your floor already know how many units they made and how long they sat idle. In most plants that knowledge dies at the machine, because the only route from the sensor to the ledger runs through a person with a clipboard.
Industrial Automation streams the signal straight into Business Central: output counted automatically, run-time captured continuously, and an alert raised when the line drifts off plan, while the shift is still running.
The problem it solves
Output counted by the machine, then counted again by a person
OEE estimated from a formula rather than measured from the line
Idle time invisible until the shift report is compiled
Off-plan drift found at the end of the run, when it is already a scrap number
A plant full of data that never reaches the ledger
How it works
- Tap the signal. Sensors and machine controllers are read directly: the count, the run state, the cycle time. Nothing is retyped.
- Post to the ledger. Output posts automatically against the production order, so the ledger reflects the machine rather than a summary of it.
- Measure run-time and OEE. Availability, performance and quality computed from what the line actually did, the only version of OEE worth acting on.
- Alert on drift. When the run goes off plan, someone is told during the shift, not shown a chart about it the following week.
What it includes
- Sensor & machine data capture
- Automatic output posting
- Run-time & OEE tracking
- Off-plan alerting
| Inputs | Machine sensors, controllers, counters |
| Posting | Automatic output against the production order |
| Metrics | Run-time, availability, OEE |
| Alerting | Off-plan drift raised in-shift |
Prints as a clean document — no navigation, no calls to action.
See it on your data
A datasheet describes what it does. A demo shows what it does for you.
We will walk the same ground against your items, your bins and your process, and tell you where the standard product already covers it — which is sometimes the answer.